If your window is lot pre-equipped with roller brackets nail our brackets 3D and 3G at the top corners of the window.

a) Fix parts 2G and 2D onto side tracks 4G and 4D. Position the side tracks 4D and 4G at the bottom corners of the windows.

b) Mark the screw holes

c) Remove the side tracks and screw the two bottom screws without entirely tightening the screws. Leaving a space of at least 2mm

a) Fix the Roller case (1) into the brackets by moving upwards from the bottom to snap into place.

b) Fix the screws, left and right, behind the roller case

Carefully remove the tape which holds the cords letting them hang freely, making sure that they fall behind the plastic at both ends of the handle bar.

ATTENTION: never unroll the blind before fixing the side tracks.

a) Place one side track at the far end of the handle bar sliding it upwards to fit over the plastic parts at the end of the roller fabric.

b) Then draw the cord downwards and introduce the plastic ball at the end of the cord into the hole in the plastic part 2 at the bottom end of the side track. Repeat the same operation at the other side drawing the cord firmly downwards.

c) Line up the side tracks with the screw holes to position the tracks before screwing firmly into place.